Case
= Type 304 Stainless steel and plated steel |
|||||||||||||||||||||||||||||||||||||||||
Window
= Polycarbonate |
|||||||||||||||||||||||||||||||||||||||||
Internals
= Brass
|
|||||||||||||||||||||||||||||||||||||||||
|
|||||||||||||||||||||||||||||||||||||||||
| |||||||||||||||||||||||||||||||||||||||||
For
the measurement of fluid liquids that are not:- highly viscous, high
temperature (over 60°C), likely to solidify/crystallize or corrosive to
copper or tin alloys. Also suitable for gases (except oxiding
gases such as oxygen or acetylene) up to 25 bar maximum. |
|||||||||||||||||||||||||||||||||||||||||
|
|||||||||||||||||||||||||||||||||||||||||
Glycerine
filled gauges are particularly suited to applications where
oscillating/surging pressures or vibration are present. The
damping effect of the glycerine will steady the pointer making it easier to
take a reading against the scale. |
|||||||||||||||||||||||||||||||||||||||||
Description
|
|||||||||||||||||||||||||||||||||||||||||
Check your pipe threads before you order! | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
In Great Britain BSP British Standard Pipe threads are commonly used. These are either parallel (BSPP) which normally seal on a washer or 'O' ring seal, or tapered (BSPT) which taper along their length and normally seal by two mating threads and/ or tape. | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
How to measure your thread: | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Use a tape rule or (vernier gauge) to measure across the outside of the male thread. Note that a thread that measures 0.5" is not 1/2" BSP thread! | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Using the table below we can see that 0.5" is actually 1/4" BSP thread. Similarly, a thread that measures 1.0" is actually 3/4" BSP thread.
|