DS 800x4 1 Ohm Taramps Amplifier


The DS 800×4 is a synonym for Taramps multichannel amplifier module. It has 4 channels of 200 Watts RMS, with maximum power of 800 Watts RMS, impedance of 1 ohm and is compatible with any frequency, that is, it is FULL RANGE. Versatility, efficiency and quality in a single Taramps product.


Technical Information:

OPERATION CLASSD
NUMBER OF CHANNELS04
MAXIMUM POWER
@ 12,6 VDC - 1 OHM: 800W RMS (4 x 200W RMS)
@ 12,6 VDC - 2 OHMS: 544W RMS (4 x 136W RMS)
INPUT SENSITIVITY250mV
SIGNAL TO NOISE RATIO>88dB
FREQUENCY RESPONSE10Hz to 36KHz(-3dB)
CROSSOVER HIGH PASS (HPF)90Hz (-12dB/8th) Fixed
CROSSOVER LOW PASS (LPF)90Hz (-12dB/8th) Fixed
INPUT IMPEDANCE18K Ohms
OUTPUT IMPEDANCE1 Ohm
PROTECTION SYSTEMOutput overload
MIN. SUPPLY VOLTAGE9VDC
MAXIMUM POWER SUPPLY VOLTAGE16VDC
CONSUMPTION AT REST1,0A
MAXIMUM MUSIC CONSUMPTION@12.6VDC: 51A
MAXIMUM CONSUMPTION IN SINUSOIDAL SIGNAL102A
DIMENSIONS (H X W X D)7.17" x 2.05" x 8.94"
WEIGHT3.52lb
EAN7898556844826

Warranty: 
Taramps products come with a 1 year limited warranty from the manufacturer. This warranty does not cover: Burnt voice coils, abuse and damaged caused by improper use or installation, physical damage to the product cause by the consumer, installation charges incurred, damage to amplifiers when connected at less ohm load than specified by the manufacturer, damage to amplifiers caused by insufficient electrical requirements, water damage, excessive wear and tear, and any other cause implied in the warranty card supplied by the manufacturer.

Shipping:
We offer free Same-day shipping to the USA. For international shipping, please ask for availability.

Return Policy:

You may return most new, unopened items within 30 days of delivery for a full refund, less any shipping costs and re-stocking fees.

  • All items returned that are not defective, in NEW condition, and unopened will be applied a 15% re-stocking fee; this fee covers shipping expenses when sent and handling

  • We shall issue the refund upon return (once the item has arrived at our warehouse). All returns will be inspected upon arrival and applied a re-stocking fee of between 15% to 50% dependent on the condition of the item returned

  • The customer must ensure that the item is adequately wrapped, secured and that it includes all components (including free items) when returning the item

  • No components should be missing, including screws, manuals, cables, protective films, plastic coverings, etc. The item returned must be in NEW condition. The factory seal cannot be open in any case


FAILURE TO MEET ANY OF THESE REQUIREMENTS WILL RESULT IN A HIGHER RE-STOCKING FEE OR DENIAL OF RETURN REQUEST