Contains everything you need to compliment your intake manifold installationFits 1955-1985 small block chevy engines including 283, 305, 307, 327, 350, 383 (stroker), 400, and others based on the popular platformMade from high quality components and assemblyIncludes Fel-Pro # 1205 intake gaskets (left and right ) & 2 rubber end seals, 12 intake bolts, Intake Bolt wrench ,distributor gasket, chrome distributor hold down with bolt , 2 of each 1/8 “ npt, 1/4 “ npt, 3/8 “ npt, & 1/2 “ npt pipe plugs, chrome thermostat housing with o-ring seal & 2 bolts, heater hose fitting, chrome throttle spring bracket, carburetor stud kit with 4 studs, 4 nuts, and 4 flat washersNote: the intake gaskets in this kit do not have the heat riser port provision. these are recommended for intakes that do not have a heat riser crossoverNote: The Intake gaskets in this kit do not have the heat riser port provision. These are recommended for Intakes that do not have a heat riser crossover.
Intake Manifold Install Kit Includes:
- (2) Fel-Pro #1205 Intake Manifold Gaskets (2.09 x 1.28 Port Size .060 Thick )
- (2) Fel-Pro Intake Manifold End Seals
- (12) Intake Manifold Bolts: 3/8 in.-16 x 1 in. L with 12-Point 3/8 head
- (1) Distributor Base Gasket
- (1) Chrome Distributor Hold Down with 3/8 in.-16 x 1 in. L Bolt with 9/16 in. Hex Head
- (2) 1/8 in. NPT Pipe Plugs
- (2) 1/4 in. NPT Pipe Plugs
- (2) 3/8 in. NPT Pipe Plugs
- (2) 1/2 in. NPT Pipe Plugs
- (1) Chrome Thermostat Housing with O-ring Seal and 2 Attaching Bolts
- (1) Heater Hose Fitting: 1/2 in. NPT x 1.750 L x 5/8 in. I.D.
- (1) Carburetor Stud Kit:
- (4) Studs: 5/16 in.-18 Bottom Thread x 5/16 in.-24 Top Thread x 2 in. Long
- (4) 5/16 in.-24 Nuts
- (4) 5/16 in. Flat Washers