These are brand new reproductions, screened on 3M brand 'foil-cal' foil-faced, sticky-baked decal stock.  This thick foil is matte finish and looks near-identical to the finish of the factory aluminum tags.  I tried to capture the reflectivity in the pictures as best I could.  See before and after photos above of a sample card (and yes, I know it's on upside down!  be careful to double check before applying - while they can be re-positioned, they don't look as good afterwards)

Each sheet contains one each of the most common Studer logic card tags.  These often get lost, broken or tossed when cards are updated and there's been no where to get replacements...until now!

These can be cut out with good, sharp scissors (although we recommend a desk shear for the best results) applied over an existing (incorrect) card tag OR directly to the white plastic piece that normally holds the tag - it will stick to both equally well.

I did a one time special run of these for my clients and I'm selling off the surplus here, when they're gone - they're gone.

Tired of ugly, broken or outright missing card tags?