Please note these stickers will only stick to smooth non-porous surfaces, 
eg glass, varnished wood, metal and plastic :)

Please see the COLOUR CHART picture, 
If you would like a different colour than the one in the picture, 
please be sure to send me a message once you have purchased your sticker :)
If you send a message at checkout please be sure to click SAVE :)

Measurements are in the pictures 


EASY APPLICATION 
Please Note - Before applying sticker the surface must be clean and dry 

Thanks for looking :)


All of these Stickers are external :)
If you would like it reversed send me a message :)

STEP 1
Make sure that you clean the area thoroughly with soap and water then dry.
STEP 2
Prepare the sticker for application by firmly rubbing a bank card or similar 
across the length of the sticker. This makes the sticker cling to the application tape.
STEP 3
Slowly peel the paper backing off of the sticker. All parts of the sticker 
should now be on the application tape. If any parts of the sticker 
cling to the backing, slowly replace the paper and repeat step 2
STEP 4
Place the sticker onto the desired surface and rub it in place firmly with a 
bank card or similar.
For best results wait a few minutes before moving on to the next step
STEP 5
Slowly peel the backing paper off at an angle. 
Be careful not to pull the sticker off the surface. 
If the sticker pulls away from the surface please repeat the previous step.