This is a custom built drone by xFold™ (Drones by Kaizen Aerospace) with a DJI Flight Controller.

It can carry 12 lbs for about 15 minutes using dual 10000mAH Lipo's and the range is determined more by the payload and batteries being used than by the radio or video signal. Our typical payload was roughly 15-18lbs and flew just about every cinematic camera that would fit - Red, Alexa, Blackmagic, etc. We used the Movi M10 and M15 as our gimbals (not included).

Drone itself: just needs to be put back together, the booms screwed back into the hub and ESC connectors plugged back into the motors. Add batteries and you'll be able to fly. 

Size: Standing on its side, 34” x 34”

Hours - this drone, including ESC’s, motors, etc all have roughly 325 hours of flight time. It was primarily used to document the construction of the Apple Campus in Cupertino and was always stored in a Pelican case and very well taken care of.  The Pelican case is no longer available, does not come with one. We did check ups on it after every day of flying and maintenance when needed but thoroughly examined it weekly as we were always flying near construction workers. It has not been in any accidents. It was also flown very slowly/cinematically but could easily be used for X-Class racing.  It has not been flown in rain.

Includes:

Frame

X8 Frame, Hub, Booms

Carbon Fiber Star Camera Mounting Plate

Flight Controller

DJI Wookong Flight Controller, IMU, GPS/Compass V2, Power Distribution Board

DJI iOSD Mini

Motors

8 Tiger U7 Motors

8 T-Motor ASC’s (ESC’s) T80A 400Hz 2S-6S

Transmitter

Graupner MX 20 Radio, SJ Hott GR-16 Transmitter, 2.4GHz

Propellers 

8 T-Motor NS16*5.4 Carbon Fiber Props (used)

8 Plastic Props (used)

Landing Gear

DJI S800 Landing gear - needs work (these are not included in the price, adding them for free)

Does not include:

No batteries

No gimbal

No camera