BRAND NEW set of premium cartridge mounting hardware in NICKEL PLATED BRASS.


Our largest assortment of screw lengths offering a wide range of compatibility with varying headshell and cartridge setups.
7 sets of screws ranging from 6mm to 20mm thread lengths.

Included in this set are 3 sets of nuts with 1 set thinner in thickness allowing a more precise selection of screw thread lengths.
Completing the set are 100% organic cellulose fiber washers offering high rigidity and stiffness that protect your headshells and cartridges from abrasion.

Everything included in this set is NON-magnetic and will not interfere with the strong magnets in moving coil cartridges.


The screws and nuts are precision machined in high purity brass with high copper content and very low iron and cadmium content.
Plated with nickel, this set resists corrosion and the formation of copper sulfide/sulfate which is an inevitability on unfinished brass surfaces, especially on commonly found low purity alloys.
The plating retains the superior sound quality over stainless steel and keeps harmful corrosion off your turntable front end and records.

____________


Please refer to the dimensions below to make sure these will fit your headshells and cartridges.
The screws are compatible with Micro Seiki headshells.

Made in Japan and USA