RGBIC and PRO Angled Permanent Light Mounting Brackets:
For each model there are a total of 5 parts: H Mounting Bracket with 4 Screw Holes, Bolt, Cap, Bracket to hold the Light that swivels on the bolt, and a Cover with 2 wings that snap in place to hold the light onto the Bracket. Maximum angle is approximately 45 Degrees. Please see video for demonstration on how to load your light onto the bracket.
1) RGBIC H705A, H705B, H705C:
This custom 3D Printed Angled mounting bracket is specially designed for the Govee RGBIC LED Permanent Outdoor Lighting. Models H705A, H705B, and H705C. It is specifically designed to secure the lights to your soffit and fascia on your home. Over time, the 3M adhesive breaks down in the weather, and this mounting bracket will prevent the Govee light from falling. By installing this bracket, you can protect your investment and only have to install your Outdoor lights once. We recommend you install your lighting using the 3M Tape first, as per your Govee Lighting Instructions, and then install these mounting brackets.
We designed these Mounting Brackets to leave the top of the light exposed. This is to ensure the light is doing its #1 job which is to shine light onto your home and not the Mounting Bracket.
Make your Permanent Outdoor Lights More Permanent!
These brackets are printed with PETG Filament. PETG is a plastic that is Ultraviolet, Temperature, and Water Resistant which makes it excellent for outdoor use. In addition, PETG is more durable, and less brittle than other commonly used filaments and is also impact resistant. PETG is also recyclable.
Screws are not included, but it will fit any #8 screws.
Approximate Dimensions:
Length 7cm
Width 6cm
Height 5cm
*Govee RGBIC Outdoor Lights are not included and are for display purposes only. *
2) PRO H706A, H706B, and H706C:
This custom 3D Printed Angled mounting bracket is specially designed for the Govee Permanent Outdoor Lights PRO. Models H706A, H706B, and H706C. It is specifically designed to secure the lights to your soffit and fascia on your home. Over time, the 3M adhesive breaks down in the weather, and this mounting bracket will prevent the Govee light from falling. By installing this bracket, you can protect your investment and only have to install your Outdoor lights once. We recommend you install your lighting using the 3M Tape first, as per your Govee Lighting instructions, and then install these mounting brackets. We designed these Mounting Brackets to leave the top of the light exposed. This is to ensure the light is doing its #1 job which is to shine light onto your home and not the Mounting Bracket.
Make your Permanent Outdoor Lights PRO More Permanent!
These brackets are printed with PETG Filament. PETG is a plastic that is Ultraviolet, Temperature, and Water Resistant which makes it excellent for outdoor use. In addition, PETG is more durable, and less brittle than other commonly used filaments and is also impact resistant. PETG is also recyclable.
Screws are not included, but it will fit any #8 screws.
Approximate Dimensions:
Length 7.5cm
Width 6cm
Height 5.5cm
*Govee Permanent Outdoor Lights PRO are not included and are for display purposes only. *
Attribution:
Title: Angled Permanent Light Mounting Bracket RGBIC
Title: Angled Permanent Light Mounting Bracket PRO
Author: Katt Shop 3D Printing