If you like me and love your Bambu Lab P series but hate the LCD that it comes with there is a way to vastly improve this issue.
I have a couple of these printers as well as the X1c which is a breeze with the screen and this is the best solution I've found so far.
All you need to do is edit the .JSON file on the card supplied, with your Wifi credentials and Roberts your Fathers Brother..... a nice new colour screen for your printer (Very easy - I can help with this if needs be)
The best upgrade for the Bambu Lab available in my opinion.........
Now .....there is the Panda Touch for the Bambu Lab series. I have this also to compare with the Xtouch and I must say this is just as good functionality wise if you're not using the AMS due to the simplicity of access to the controls. The screen graphics aren't as good but they're absolutely fine and one other thing I've noticed is that you can't raise the bed easily on the Panda but on the Xtouch it's right there on screen (which is handy when your on a flap)
Also mine was £55 when I bought it and i didn't realise you should also buy the magnetic bracket for a good installation. these are an extra £15 as you can see its totting up. At less than half the price and for me personally in the spirit of 3D printing and the extra bracket thing, I would have preferred to make my own. especially if you're not bothered about the AMS (hopefully a future update will resolve this)
As you can see in the photo. There is no need to even remove the old screen but there are loads of options - It doesn't even need to be in the same room as its WiFi -
This Listing is for the Brand New ESP32 Touch with flashed Xtouch Firmware
and an 8Gb SD card for your wifi details - You're better off getting the enclosure you like. This is just the one I preferred