New 10 Pack Replacement Quartz Clock Movement Mechanism Motor & Metal Hands & Fittings
REPLACEMENT MOVEMENT EASY ORDER SYSTEM
1 - Remove your old
movement (Black box)
2 - Measure the
spindle length (protruding Gold & plastic piece) and match to the chart
below
MOVEMENT |
SILVER THREAD
|
TOTAL |
WIDTH |
Short – For clock
faces up to 3mm thick |
6.7mm |
14mm |
7.6mm |
Medium – For clock
faces up to 9mm thick |
11.7mm |
19.5mm |
7.6mm |
Long – For clock
faces up to 12mm thick |
15mm |
20mm |
7.6mm |
Extra-long – For
clock faces up to 18mm thick |
20mm |
28mm |
7.6mm |
Supersize – For
clock faces up to 22mm thick |
24mm |
32mm |
7.6mm |
3 – Decide on ticking or non-ticking
4 – Fill in your information in the drop-down box’s above
5 - Hand measurements shown are taken from the centre of the minute hand
hole to the tip of the minute hand
6 - Hangers can be removed on request
7 – Add the quantity required
8 – Then simply buy it now or add to basket to continue
The colour of the movement thread can vary between gold and silver depending on stock availability. If you prefer a certain colour, please contact us, and we will do our best to match the colour required.
- 10 Movements and 10 sets of hands available in 5 spindle sizes - Short, medium, long, Ex long & SUPERSIZE
- Ticking - Standard ticking
- Non ticking - Second hand sweeps rather than ticks for a quieter movement (not silent)
- Movement dimensions - height 70mm (55mm with hanger removed) - width 55mm - depth 16mm
- Press fit metal hands in sizes 24mm - 130mm (Please select above).
- Hand measurement shown is taken from the centre of the minute hand hole to the tip of the minute hand
- Hands come with a removable protective seal
- Complete with all fixings
- The movement brand and shaft colour can change from the photo's attached and although the silver thread and OK888 movement is used with most orders this may change on some occasions but a compatible model will still be sent
- Mixed combinations available, please contact us with any requirements
- ROHS approved
- Hangers can be removed on request (this will leave a small scratch to the top of the movement)
- Fully tested
- Fitting instructions included