Product Description
Warm and Sweet Tips:
If you have any questions about our product, please contact us first, before opening return or case, we will help you with it.
We will reply you within 24 hours in working days.
I'm a new seller, thanks a lot for your trust and convince! I will serve you with all my heart.
Please check fitment notes & description for
accurate information before buying
Where are my oxygen sensors located?
Part Number/OEM Number
234-4331 234-4294
Specifications
Bulit to strict quality control standards
100% test before shipment
Replacement: Direct Plug-In Replacement
Warranty: 1 Year
Condition: 100% Brand New
Fit Vehicles: Please refer to the compatibility table
for details
Isuzu
I-290 2.9L L4 2007 2008
I-370 3.7L L5 2007 2008
Ascender 4.2L L6 2007 2008
Saab
9-7X 4.2L L6 2007 2008 2009
Buick
Rainier 4.2L L6 2007
Chevrolet
Colorado
2.9L L4 2007 2008 2009 2010 2011 2012
3.7L L5 2007 2008 2009 2010 2011 2012
Trailblazer 4.2L L6 2007 2008 2009
Hummer
H3 3.7L L5 2007 2008 2009 2010
H3T 3.7L L5 2009 2010
Gmc
Canyon
2.9L L4 2007 2008 2009 2010 2011 2012
3.7L L5 2007 2008 2009 2010 2011 2012
Envoy 4.2L L6 2007 2008 2009
-For Autometer
-For FAST
Package Include:
2pcs oxygen sensor
Note:
Communication is the best way to solve the problem. If you have any problems after purchasing,
please contact us in time, before opening return or case.
Contact us:
1. Negative feedback will not help resolve any problems you have, please contact us via eBay messages before leaving negative feedback, our customer service will make best effort to help you with the issues.
2. We maintain high standards of excellenceand strive for 100% customer satisfaction! Feedback is very important to us. We request that you contact us immediately Before you give us neutral or negative feedback, so that we can satisfactorily address your concerns.
How to replace an oxygen sensor?
1- Disconnect the battery.
2- Locate the sensor connector by following its wires. Disconnect it.?
3- Remove the sensor cable from its clips all along its way to the sensor.
4- A specific 22mm socket with side cut out exists (see below). You can use a spanner instead. Hold it in one hand and give it a firm hit with the other hand. It will then unscrew very easily.
5- Remove the sensor and fit the new one.
6- Re-route the cable carefully and meticulously and fix it at every clip. Reconnect the connector.
7- Reconnect the battery and wait 5 minutes before starting the engine.
Please take a video clip of the voltmeter and contact us if our sensor:
Goes above range between 0.1 and 0.9 volt
Remains below 0.5 volts
Stays fixed at a particular voltage
You're free to choose replacement or refund if our sensor fails to work, in this case.
We greatly appreciate your positive feedback.Please do Not leave negative feedback without asking for help.
Our aim is to provide TOP level customer service,so we will always try our best to solve any question or problem you have.