What you get
1 x Press N Snap tool
1 x Cap die
1 x Socket die
1 x Post die
1 x Stud die
Directions
To remove dies from tool pull/twist.
To install dies onto the tool push/twist.
Select and attach the appropriate die set for the job at hand.
With the handle closed Adjust the end bolt until the two dies come in contact, being careful not to cut the M2700 grey retaining ring.
Place fabric between the dies and press / squeeze the handle.
Fasteners should not rotate when set in fabric.
CAUTION: Over tightening may cause distortion to fasteners and dies. It is advisable to make several practice settings.