CODE ALARM

CRCX3

• Code Alarm, Chapman, Chrysler, Ford, GM, Mitsubishi, Subaru 2 button 314MHz replacement transmitter remote (Control modules with FCC ID: GOH-052-RMTPL, GOH-3YK-BTPRX, GOH-717-JLK)
• FCC ID: ELVATKC (Replacement for GOH-M24, GOH-M41-014, GOH-MM6-101890)
• Programmable to the following models: ALLPRO2500, Autobahn, C-350, Chapman-400, Chapman-450, Chapman-500, Chapman-650, CSM2.5, ELITE1100, ELITE1500, ELITE2000SE, ELITE4500, ELITE911, ELITE950, EVS, EVSII, MIRAGE4500, MIRAGE9000, NIGHTHAWK4.0, PRO100, PRO1000, PRO200, PRO3000, PRO3500, PRO750, RCS2, RKE1, SCORPION600, SURESTARTSE, SURESTARTSE433, VSS-200, VSS-250, VSS-350, XTPLUS4.0
• Replacement may vary from image due to cosmetic changes by manufacturer changes but will still work and program the same 
• You need to locate and use the system's VALET SWITCH to perform the programming procedure, but on some models it is possible to perform programming without the valet switch (access to the receiver under the dash is required)

Programming Instructions

Note: This mode will only retain the last 4 remote transmitters programmed. If the transmitter memory is exceeded, the security system will start deleting transmitters from memory in chronological order.

To program transmitters:

1. Turn the ignition ON.
2. Press and hold the valet/override button.
3. Within 10 seconds the system will