3d printed Death Viper Head inspired by the cobra Alley Viper
Designed by Jcirion3d

Printed in Resione M70 (subject to change without notice)

The ( ) Signifies a JsArmory Part Bin Location

Color may vary

Heads will need to be fitted for the figure you choose. You can get away with sticky tack on the ball peg but a more permanent solution is best. Dremeling, putty, etc may be needed to ensure a proper fit. I use a method that utilizes hot glue. Use petroleum jelly on the neck peg. Fill the head hole with enough glue to push the peg into the head and some of the glue to squeeze around the neck ball. As it dries, continue to move the neck peg so it will not bind in the hole.

NO FIGURES ARE INCLUDED. ONLY THE HEAD.

There will be differences and imperfections in each piece including small flaws in prints. I strive to make quality items. Please understand that these are more fragile than a manufactured item. Please handle them with care.

Thank you so much for considering a purchase!
All hand-painted items present the chance of paint rub. Either the paint off the item or the paint off the item onto the figure. This isn't very common with the finish I use, but it has happened. Please handle the items with care. If placing a vest onto a figure and it needs to be shaped first, please warm it slowly with a hair dryer. Thank you!