This unit is in excellent condition (see photos) and plays great producing wonderful sound. Over the years unit has been lightly used by single owner.


The Dynaco Stereo 80 all Silicon basic power amplifier is a vintage gem that will surely elevate your audio experience. With its impeccable build quality and timeless design, this power amplifier is a must-have for any audiophile or vintage electronics enthusiast. Featuring Dynaco's iconic sound signature and boasting a powerful output, this amplifier is perfect for powering up your vintage speakers or classic audio setup. Its top-notch components and attention to detail make it a true collector's item that is sure to impress.

SPECIFICATIONS
FREQUENCY RESPONSE: 10 Hz to 50 kHz =0.5 db. POWER OUTPUT: 30 watts average continuous power per channel into 8 ohms over a power bandwidth of 20 Hz to 20 kHz at Jess than 0.5°/o kHz total harmonic distortion. Distortion decreases at lower power levels.INTERMODULATION DISTORTION: Less than 0.1°/o cb onanat any power level up to rated power with any combination of test frequencies. Distortion de- creases at lower power levels.

NOISE: 90 db below rated output.

DAMPING FACTOR: Greater than 40 from 20 Hz to 20 khzSEPARATION: More than 60 db from 20 Hz to 10 khz

INPUT: 100,000 ohms; 1.3 volts for 40 watts output.

SEMICONDUCTORCOMPLEMENT: 12 transistors;

10 diodes.SIZE: 14° x8 x4.WEIGHT: 13 lbs.MAXIMUM POWER CONSUMPTION: 250 watts.
SQUARE WAVE PERFORMANCE: This is a good indication of linearity from 10 Hz to
100 kHz, since good square wave reproduction requires bandwidth in excess of
1/10th to 10 times displayed frequency.(See picture wave 1)LOW POWER FREEDOM FROM DISTORTION: at 1/10th watt, a 20kHz sinewave (the most
difficult audio frequency) shows absolutely no signs of cross-over or notch
distortion. (See picture wave 2)