What is PETG?
PETG is a specialist food-safe 3D printing material made
from recycled bottles and containers. PETG offers flexibility, strength and
temperature resistance. Unlike many plastics, PETG does not leach chemicals
when submerged in water.
When purchasing 3D printed parts to use inside of your
aquarium, sump or storage tanks, always ensure they are constructed using PETG.
Super simple installation:
1.
Remove the white thread collar from the optical
sensor and feed the plug down through the sensor mount.
2.
Pass the thread collar up the wire and screw to
sensor (finger tight, do not over tighten).
3.
Pass the sensor cable through the smaller cable
guide hole (You can then use a nylon zip-tie to secure to the pump cable).
4.
Gently snap the bracket around the pump body and
slide to bottom.