This is a magnetic holder with a hole through to accommodate a zip tie. If you can't find a standard holder for whatever you're planning, then this is the holder for you! The hole is a little over 1/4" which should fit most light to medium duty zip ties. The dimensions are 1 3/4" W x 1" L x 1" H. The curvature on the front is appropriate to accommodate from smaller to larger diameter objects. This holder is ideal for tubing, piping, heaters etc. The magnets are pre-coated resin neodymium N50 high strength magnets capable of holding on less than 1/2" glass (1/2" will probably work).
If this size/orientation doesn't work for you please contact me and I can modify this to your needs. If you use with a glass heater, make sure to not over tighten the zip tie so as to not break the heater. Use caution with any application.
*The zip tie is not included, it's shown for reference.
Please note that these are 3D printed parts. That means that the surface finish quality of the part will not be directly comparable to an injection molded part. Although not very common, there might be small surface finish defects, or rough spots. The goal is to have a fully functional, as described part. This disadvantage to 3D printing is reflected on my pricing as well. Polished surface finishes, is definitely something that can be achieved to a certain degree with 3D printed parts, but it's a time consuming process, something that definitely cannot be offered for the price range my products go for.