Gibson SG JR Wiring Harness! CTS - Mojo - Switchcraft! NEW!

STARR GUITAR SYSTEMS electronics for Gibson SG JR! Each set is assembled, hand wired and soldered in the USA by Dave Starr using premium USA parts. Get rid of the tone sucking PCB electronics on your modern SG JR, or replace your old worn out parts with these premium replacement units! All units are signed by Dave Starr and have their own serial number. FREE SHIPPING!


Included in each SGJR set:
2) CTS 500K pots, split shaft, 3/8 inch tall threaded portion
1) Mallory .022 Capacitor 630 volt
1) Switchcraft #11L input jack
1) 22 gauge shielded single conductor master wire
1) 18 gauge solid tinned copper ground wire
1) Wiring diagram (see photo section)
1) Assembly template board


Note: Most guitars manufactured overseas in Korea, Japan, China, Indonesia and Mexico use 6mm metric pots and have metric sized holes drilled. You will need to enlarge the pot holes to 3/8" diameter to fit these CTS pots properly.

Starr Guitar Systems
PO Box 3132
Conroe, TX. 77305