Waterproof Cover For iPhone 14 13 12 11 Pro Max Shockproof Case Camera Protector
1. Applicable to iPhone Series.
2. The appearance of the product is simple and round, the front shell is made of hard glue and soft glue, the outer ring is made of soft glue, and has a groove anti-skid design, and the rear shell is frosted and translucent.
3. The protective case has the functions of waterproof, anti-drop and dustproof, and the protection level is IP68, that is, the waterproof is 1.5m deep, and the protection lasts for 30 minutes.
4. It can accommodate general mobile phones with or without tempered film, except that the thickness of tempered film exceeds 0.5mm
Installation method and instructions
1. A waterproof test is required before use: cover the front and rear shells of the mobile phone, put it into the basin and press the glass water cup on the bottom, confirm that there is no water leakage after half an hour, and then install the mobile phone
2. Tear off the blue film inside the front shell of the phone case
3. Wipe the screen of the phone with a dust-proof cloth
4. Tilt the side of the mobile phone's mute pull button into the front case (the purpose is to introduce the mute button into the transmission slot), and fully press the mobile phone into the mobile phone slot
5. Close the back case and check whether the four sides are in place
6. Open the rubber plug of the charging port, flatten the screen film of the mobile phone by hand, discharge the air between the film and the screen, and then cover the rubber plug
7. Check the function response of the button and the pull button. If the function is normal, the installation is completed. Otherwise, repeat the steps after step 3.
Package Inclusions and Specifications
1. Mobile phone front shell and back shell
2. Manual
3. Shell opener
4. Dust cloth
5. Lanyard