Completely wired (Not a kit) - Ready to install
Made in USA by Charlies Gear
Features:
Master volume / Master tone / 3 way blade switch
Designed for 2 humbucker models (H-H)
Solderless installation
Bourns pro-audio push/pull potentiometers
Volume - Pull up knob for single Coil - (Controls both pickups)
DGT style coil splitting mod with balance resistor added for bridge pickup
Tone - Pull up or push down knob to switch between series or parallel
3 way blade switch - switching: B / B+N / N
2 hardware grounding options to ground strings & hardware
Multi-contact jack with 100% more signal transfer area
22 gauge wiring
The easiest installation & future pickup swap system available
See complete component spec's below
Important note:
These potentiometers & jack require 3/8" diameter minimum size mounting hole
(affordable hand reamers are available in "helpful tools" in this store if you need one)
Installation:
This system is designed to make upgrading your electronics with premium components easy, quick and frustration free.
1- Slip your stripped wires into the solderless terminal ports and secure with the included screwdriver.
2- mount your new harness in the control cavity
3- plug the solderless terminal into the harness.
BING - BANG - BOOM - DONE!
Plus, no burned fingers!
***Makes future pickup upgrades a snap***
Specifications:
Master volume / master tone / 3 way blade switch
Bourns pro-audio 500k 17mm push / pull pots
Short shaft mounting bushing: 3/8" diameter x 3/8"long (threaded section)
Split shaft with coarse spline (for knobs)
N.O.S. K73-11 .022uF tone capacitor
2.2k Resistor added for bridge coil split
Oak Grigsby 3 way blade switch
Pure tone multi-contact mono jack
22 gauge wiring with silicone jacket
2 hardware grounding options included
Premium quality solderless terminals for your wiring connections
2mm screwdriver for terminal
Installation wiring guide
Fast shipping with USPS Ground Advantage delivery
Check out Charlies Gear for wiring harnesses galore
over 300 models in this store!