Working voltage: 5V Version (DC 3.7-6V);12V Version (DC 10-15V); 24V Version(DC 18-25V)
Working current: 90MA/60MA/30MA(Provide current only when switching states)
Standby current: 20-30uA(OR zero power consumption standby )
Load current : AC 120V/10A, DC 24V/10A
Trigger mode: Low pulse trigger
Size: 48mm * 17mm * 17.5mm
Weight: 13g

Module interface:
1. V: Positive power supply (VCC)
2. G: Negative power supply (GND)
3. R : Reset(CON disconnect NO)
4. S : Set( CON connect NO )

Relay outputs:
1. NO: normally open relay interface
2. COM: Common Interface Relays
3. NC: normally close relay interface

This is a latching(keep) relay module,Trigger S Pin , the relay pull (and holds);Trigger R Pin, the relay releases (and holds)
The trigger duration is 0.1-2 seconds, it is recommended not to exceed 50 seconds .

Typical applications:

Question:
What's a Magnetic latching relay?

Answer:
Magnetic latching relay is a new type of relay developed in recent years. It is also an automatic switch. Like other electromagnetic relays, it can switch on and off the circuit automatically. The difference is that the normally closed or normally open state of magnetic latching relay completely depends on the action of permanent magnet, and the switching state of magnetic latching relay is triggered by a certain width of pulse electric signal.