"Vintage Relic pre-wired upgrade kit with BLENDER and VOLUME MOD fits Fender Stratocaster! New. This is the best and most economical way to improve the tone of your Strat!

• 2 CTS 250k split shaft pots (10% tolerance). 1 volume, 1 tone. We measure each pot and use ones with higher readings for the volume pot (~275k).
  
  
• 1 Fender 5-way control switch. Includes a white plastic switch tip.
  
  
• 1 NOS PIO (paper in oil) tone capacitor. New old stock Russian .047uF 200V capacitor. We add cloth shielding to the terminals to prevent a "ground out." These are GREAT sounding caps. TONE!!
  
  
• "Blender" Strat wiring. In place of the second tone pot is a Fralin / ACME Blender pot which allows blending of the neck or bridge pickup; this allows for some very different and cool sounds! The first tone pot is a "master" tone control for all pickups. Pickup selection is as follows:
  
  5. Neck pickup; Blender mixes in the Bridge pickup
  4. Neck/Middle pickups; Blender mixes in the Bridge pickup (yes, all 3 pickups at once!)
  3. Middle pickup
  2. Middle/Bridge pickups; Blender mixes in the Neck pickup
  1. Bridge pickup; Blender mixes in the Neck pickup
  
  
• Volume Mod / Treble Bleed. More treble/highs retained as the volume knob is turned down. .001 uF ceramic disc capacitor & Vishay 100k resistor.
  
  
• Ground wire and jack wire already soldered to the harness for easy install.
  
  
• Mounted on a Fender '57 aluminum control shield (Fender P.N. 001-9640-000).
  
  
• All cloth vintage style 22 ga push back wire.
  
  
• Wiring diagram included."
  
  
  Distance between the components (center to center); if you need different spacing, let us know:
  
  switch to volume = 2.0"
  volume to tone 1 = 1.75"
  tone 1 to tone 2 = 1.75"
  
  Above text and pictures copyright Vintage Relic. All rights reserved.
  
  
• Pot specs:
  Tolerance = +/- 10% 
  Can Size = 15/16 in. radius X 3/8 in. height
  Bushing Threads = 3/8-32 
  Bushing Height = 3/8 in. 
  Shaft Type - split 
  Shaft Diameter = .238 in (6.3mm) 
  Spline Count = 24 (NOT metric) 
  Shaft Length - 3/8 in. 
  Hole size requirement = 3/8 in. 
  Value = 250K Ohms