• Fitment:
  •  
  • 2002-2004 Infiniti I35  2002-2003 Nissan Maxima
  •  
  •  
  • Notes:
  • The radiator cooling fan is an integral part of your car that is responsible for cooling the radiator of your car. The radiator cooling fan does this by either pulling or pushing air into the radiator keeping the radiator temperatures within the safe levels. A damaged radiator cooling fan is a determining factor in preventing your car from overheating. Below are the materials that you need along with the instructions on how to replace a radiator cooling fan.
  •  
  • Step 1: Locate the Radiator Cooling Fan

 

 

content_src_url

Radiator Condenser Cooling Fan Assembly For 2002 2003 2004-2006 Nissan Sentra

Fitment:

 

2002-2004 Infiniti I35
2002-2003 Nissan Maxima

 

 

Notes:

The radiator cooling fan is an integral part of your car that is responsible for cooling the radiator of your car. The radiator cooling fan does this by either pulling or pushing air into the radiator keeping the radiator temperatures within the safe levels. A damaged radiator cooling fan is a determining factor in preventing your car from overheating. Below are the materials that you need along with the instructions on how to replace a radiator cooling fan.

 

Step 1: Locate the Radiator Cooling Fan

Locating the radiator cooling fan is the first step in replacing it. Turn off your car and allow it to cool off. Open the hood of your car and you will be able to see the radiator that is located at the back of the grill at the front portion of your engine compartment. The radiator cooling fan is attached at the back of the radiator through a mounting frame. Under the engine and the radiator is a sticking cylinder that is encased in a small casing. That is the radiator cooling fan motor that you may need to change or repair other than the radiator cooling fan itself.

 

Step 2: Disconnect the Power Supply

On the fan motor is an electric cable running towards the engine. Find the connector of the wires from your engine and from your radiator fan motor and disconnect it. Using two masking tapes with different colors, note the connection of the wires so that you will not have a hard time reconnecting the wires later.

 

Step 3: Remove the Fan Housing

Using a crescent wrench, remove the four screws located at each corner of the fan housing. Remove the fasteners at the sides of the fan housing as well.  A radiator cooling fan housing is relatively large and you may need to remove all the obstructions like hoses and wirings so that you can extract the fan housing off your car hood. Hold the housing firmly and lift it off your engine compartment. Be careful in removing the fan housing to avoid damaging it. Place the fan housing on a clutter-free working table.

 

Step 4: Remove the Radiator Cooling Fan and the Fan Motor

The fan blade is either pinned or screwed to a shaft. With a screwdriver, loosen the fan blade and slide if off its shaft. You may need to remove a keeper that prevents the fan blades from moving up in the shaft up and down. As to the fan motor itself, remove it from the fan housing using a screwdriver.

 

Step 5: Attach the Replacement  Radiator Cooling Fan and Fan Motor

Install the new fan motor into the fan housing. Slide your replacement radiator cooling fan into the shaft, insert the keeper and secure the new cooling fan and keeper into place. Return the fan housing back into its proper place and secure the screws and the fasteners. Reattach the hoses and wires you removed in step 3. Connect the fan motor into the car electrical system using the electrical tape guide you made in step 2. You just learned how to replace your radiator cooling fan as well as your radiator cooling fan motor.

 
 
 
 
 
 
 
 
 
 
 


 
 
    
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.
  • We stand behind every product we sell.
  • All of our brand new items come with a 60-Days money-back guarantee.
  • We define the item as defective only if it doesn't function as described.
  • It is the buyer's responsibility to understand the item description before bidding.
  • We will replace the defective items, provided that they are in stock within the warranty period posted with the listing and the buyer return the  original item and pay for the S&H cost for the replacement.
  •  
  • We  will refund the purchase price if the replacement is not available or buyer  prefers a refund and send the original item back at his/her own cost.
  •  
  • Shipping & handling cost are not refundable.
  • Man-made damage by  abuse or wrong operation is not covered by this warranty.
  • No  product liability insurance is assumed.
 
  • PayPal preferred.
  • Payments are expected within 7 days  after the last winning auction is closed; Otherwise Unpaid Item Dispute  will be filed with eBay.

 ​ 

  • Product will be shipped within 2 business days after full payment is received and verified. Delivery Time is about 3-7 business days to most  of countries.
  • All domestic orders will be shipped via USPS, UPS  or FedEx from our US warehouse and usually arrives to your door in about  3-5 business days.
  • We ship the package to your shipping address in eBay instead of the one in PayPal. Please tell us your shipping address if it is different from the one in eBay.
  • The tracking  number will be given for the customer to check the shipping status online (registered or faster service only).
  • We are not  responsible for any wrong or undeliverable addresses. Please verify and  update your shipping address on eBay during checkout.

  • International Buyers a€“ Please Note:
  • a) Import duties, taxes and  charges are not included in the item price or shipping charges. These  charges are the buyer's responsibility.
  • b) Please check with your  country's customs office to determine what these additional costs will  be prior to bidding.
  • Serious Buyer Only! Please place  bid or "Buy it now" only if you agree the price and terms of the product  and no argument after the auction.

​

  • We strive to source genuine products from the suppliers. However, if you feel any of our products violate your Trademark, Patent Right or any  other Intellectual Property Rights, please contact us. We will remove any offending listing immediately while awaiting further discussion.
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

 

 

 
Picture

content_src_url

Hot Item
Shop Category
 Store Home
 Towing mirrors
 Oxygen sensor
 Sepcial LED Package Kit
 Fuel pump assembly
 Key
 Ignition coils
 Struts
 Exterior Lights
 Interior Lights
 complete struts
 Lift Supports
 Starter
 wheel spacers
 Ignition Distributor
 Exhaust System Parts
 CV axle
 Cylinder Piston Gasket Kit
 Cab Marker Roof Running Light
 Side Marker
 Trunk Floor Mats
New List Item
 
 
Radiator Condenser Cooling Fan Assembly For 2002 2003 2004-2006 Nissan Sentra
 

Fitment:

2002-2004 INFINITI I35
2002-2003 NISSAN MAXIMA 

 

Notes:

The radiator cooling fan is an integral part of your car that is responsible for cooling the radiator of your car. The radiator cooling fan does this by either pulling or pushing air into the radiator keeping the radiator temperatures within the safe levels. A damaged radiator cooling fan is a determining factor in preventing your car from overheating. Below are the materials that you need along with the instructions on how to replace a radiator cooling fan.

 

Step 1: Locate the Radiator Cooling Fan

Locating the radiator cooling fan is the first step in replacing it. Turn off your car and allow it to cool off. Open the hood of your car and you will be able to see the radiator that is located at the back of the grill at the front portion of your engine compartment. The radiator cooling fan is attached at the back of the radiator through a mounting frame. Under the engine and the radiator is a sticking cylinder that is encased in a small casing. That is the radiator cooling fan motor that you may need to change or repair other than the radiator cooling fan itself.

 

Step 2: Disconnect the Power Supply

On the fan motor is an electric cable running towards the engine. Find the connector of the wires from your engine and from your radiator fan motor and disconnect it. Using two masking tapes with different colors, note the connection of the wires so that you will not have a hard time reconnecting the wires later.

 

Step 3: Remove the Fan Housing

Using a crescent wrench, remove the four screws located at each corner of the fan housing. Remove the fasteners at the sides of the fan housing as well.  A radiator cooling fan housing is relatively large and you may need to remove all the obstructions like hoses and wirings so that you can extract the fan housing off your car hood. Hold the housing firmly and lift it off your engine compartment. Be careful in removing the fan housing to avoid damaging it. Place the fan housing on a clutter-free working table.

 

Step 4: Remove the Radiator Cooling Fan and the Fan Motor

The fan blade is either pinned or screwed to a shaft. With a screwdriver, loosen the fan blade and slide if off its shaft. You may need to remove a keeper that prevents the fan blades from moving up in the shaft up and down. As to the fan motor itself, remove it from the fan housing using a screwdriver.

 

Step 5: Attach the Replacement  Radiator Cooling Fan and Fan Motor

Install the new fan motor into the fan housing. Slide your replacement radiator cooling fan into the shaft, insert the keeper and secure the new cooling fan and keeper into place. Return the fan housing back into its proper place and secure the screws and the fasteners. Reattach the hoses and wires you removed in step 3. Connect the fan motor into the car electrical system using the electrical tape guide you made in step 2. You just learned how to replace your radiator cooling fan as well as your radiator cooling fan motor.

 
 
 
 
 
 
 
 
 
 
 
 
 
    
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.
  • We stand behind every product we sell.
  • All of our brand new items come with a 60-Days money-back guarantee.
  • We define the item as defective only if it doesn't function as described.
  • It is the buyer's responsibility to understand the item description before bidding.
  • We will replace the defective items, provided that they are in stock within the warranty period posted with the listing and the buyer return the  original item and pay for the S&H cost for the replacement.
  •  
  • We  will refund the purchase price if the replacement is not available or buyer  prefers a refund and send the original item back at his/her own cost.
  •  
  • Shipping & handling cost are not refundable.
  • Man-made damage by  abuse or wrong operation is not covered by this warranty.
  • No  product liability insurance is assumed.
 
  • PayPal preferred.
  • Payments are expected within 7 days  after the last winning auction is closed; Otherwise Unpaid Item Dispute  will be filed with eBay.

 ​ 

  • Product will be shipped within 2 business days after full payment is received and verified. Delivery Time is about 3-7 business days to most  of countries.
  • All domestic orders will be shipped via USPS, UPS  or FedEx from our US warehouse and usually arrives to your door in about  3-5 business days.
  • We ship the package to your shipping address in eBay instead of the one in PayPal. Please tell us your shipping address if it is different from the one in eBay.
  • The tracking  number will be given for the customer to check the shipping status online (registered or faster service only).
  • We are not  responsible for any wrong or undeliverable addresses. Please verify and  update your shipping address on eBay during checkout.

  • International Buyers a€“ Please Note:
  • a) Import duties, taxes and  charges are not included in the item price or shipping charges. These  charges are the buyer's responsibility.
  • b) Please check with your  country's customs office to determine what these additional costs will  be prior to bidding.
  • Serious Buyer Only! Please place  bid or "Buy it now" only if you agree the price and terms of the product  and no argument after the auction.

​

  • We strive to source genuine products from the suppliers. However, if you feel any of our products violate your Trademark, Patent Right or any  other Intellectual Property Rights, please contact us. We will remove any offending listing immediately while awaiting further discussion.
 

Copyright of eccppautoparts. All rights reserved.