Welcome to this Buy It Now listing for a BRAND NEW Stainless Steel Heavy Duty V Band Clamp. These clamps are used to secure exhaust components like Downpipes, Wastegates to Manifolds and Turbocharger. SPECIFICATIONS: SIZE 3.25" ID Exhaust TO FIT 101mm OD Flange MAXIMUM TORQUE SETTING 5NM
(NEWTON METRES) HEAVY DUTY STAINLESS STEEL 8mm M8 SHAFT THREAD ALL STEEL SERRATED LOCKING NUT CORRECT TIGHTENING OF YOUR V BAND CLAMP V Band clamps are NOT tightened excessively. They are designed to pinch the mating flanges together whilst allowing movement through expansion and vibration. Over tightening can damage clamps, flanges and in worst case pipe work. To mount your V Band clamp, butt mating flanges together and fit clamp. Tighten clamp to a torque setting of 3.5 Newton Metres (NM) Then using a rubber mallet, tap around the mating flanges to allow the joints to fully centre and sit without any unequal load. Then increase torque to its final torque setting of 5 Newton Metres (NM) Further tapping with a rubber mallet to removing any uneven load from the clamp or flange is beneficial whilst checking the torque setting stays at its rating of 5 Newton Metres (NM). To check if this clamp is for you, measure the INSIDE BORE diameter of the pipe, this is to secure and match to the size listed. IE If your exhaust has a 3.25" bore, then this is for you. PLEASE MEASURE BEFORE PURCHASE TO AVOID MISTAKES In stock in our UK workshop ready for same day dispatch (if ordered before 3pm). You are purchasing this product from Turbo Rebuild Ltd. Turbo Rebuild is a UK family run business based in Lancashire. We are professional Turbocharger Reconditioners and work from our fully equipped, purpose built workshop which houses all required machinery for the testing, repair and production of Turbochargers and Turbo parts. We have been trading in the Turbocharger market since 1998 and are fully VAT registered. We pride ourselves on the quality of the products we sell and the service we offer as our feedback shows. |