Set Of 4 Tpms Tire Pressure Sensor For Dodge/Chrysler/Jeep/RAM 56029398AB 433MHz
Note:
1.The Tire Pressure Sensor is 100% new and come pre-programmed
specifically for your make/model/year of vehicle,need activate them by scal tool or "re-learning".
2.Installation of TPMS is recommended to be performed only by trained professionals.
3.This original equipment General Motors
TPMS replacement set of (4) sensors arrives as pictured and will fit on any GM
vehicle that requires a 315 MHZ from 2007-2020.
This sensor is OEM quality and has been Manufactured for an exact fit on your GM vehicle.
Part Number:
56029398AB,56029398AA,68142397AA, 68241067AB
56029-398AB,56029-398AA,68142-397AA, 68241-067AB
Frequency:
433 MHz
Fitment:
Chrysler 300 2012-2015 W/Rubber Stem Snap-in Sensor
Chrysler 300 2011
Chrysler Town & Country Van 2015-2011
Dodge Challenger 2015-2010 W/Rubber Stem Snap-in Sensor
Dodge Charger 2012-2015
Dodge Charger 2011-2010 W/Rubber Stem Snap-in Sensor
Dodge Durango 2015-2011
Dodge Grand Caravan 2015-2011
Dodge Journey 2015-2011
Dodge Ram 4500HD 2012-2013
Dodge Ram 5500HD 2012-2013
Dodge Ram Series Pickup 2012-2013
Dodge Ram Series Pickup 2011-2010 W/Rubber Stem Snap-in Sensor
Fiat 500; 2015-2012
Jeep Grand Cherokee; 2015-2011
Jeep Wrangler; 2013-2014 (433 MHZ only)
Packing List:
4Pack Tpms Tire Pressure Sensor
Note:
Please check part number carefuylly to make sure it fits your model.
Installation Process:
1. Loosen the tire: Remove the valve cap and core and deflate the tire.
2. Dismount the tire: Clamp the tire onto the tire changer,
and adjust thvalve at 1 o’clock relative to the tire separation
head.Insert the tire toand lift the tire bead onto the mounting head to discount the head.
3. Dismount the sensor: With a screwdriver remove the fastening screw and sensor
from the Valve stem, then loosen the nut and remove the valve.
4. Mount sensor and valve: Slide the valve stem through the valve hole of the rim.
Tighten the screw-nut with 4.0 Nm with the help of the
positioning piAssemble the sensor body against the rim and tighten the screw.
5. Mount the tire: Place the tire on the rim,
making sure that the valve faces the separation
head at an angle of 180 degrees. Mount the tire over the rim.