Heat Transfer Vinyl Iron On

Can be ironed to Cotton, Poly/Cotton Blend and Polyester.

Warning: These are HTV Vinyl transfers. (THESE ARE NOT EMBROIDERY SEW ON PATCHES)

It will not work on waterproof material or nylon.

INSTRUCTIONS:

Preheat garment, press with heat press for 5 seconds.

Remove transfer backing.

Position and place cover sheet over graphic. You can use a parchment paper or teflon / cooking sheet.

Apply heat with a Heat Press at 300F for 10~15 seconds.

House Iron 300F 10~20 seconds. Medium pressure. You need to press the whole transfer. If transfer is bigger than iron surface area, press in parts. You need to press one area for 10~20 seconds, then move to the other area again for 10~20 seconds and make sure you have pressed the whole area of the transfer.  Search online for Apply HTV with an Iron.

Warm peel the transparent masking tape. If the clear transfer tape releases easily then continue to peel, if the clear transfer tape is not releasing easily, place the clear transfer tape over the printed transfer again and iron or heat press again. Then try to release the transfer tape again.

Final Press. After removing the masking film, place a teflon/cooking sheet over transfer and press for 5 seconds.

Do not wash shirt, mask or fabric where vinyl was applied before 24 hours after heat pressed.  

Washing Instructions: 

Machine wash COLD with mild detergent. NO bleach. Dry at a normal dryer setting on household machines. Do not dry clean.