Step 5:
Removing bubbles.
The final step is to remove air bubbles from the window decoration.
We do this by pushing the air out. We can achieve this by using our hands or by using a Window Cling Applicator (Available through our store. These aren't critical to use, but it does make life easier).
If your window cling isn't completely flat before you start, this isn't an issue. As you can see from the photo, i have lifted up the window decoration. This was due to the film not being completely flat before hand.
With one hand (In my case, my non-dominant hand) held the window film away from the glass whilst my dominant hand pushed left and right on the glass, pushing the air bubbles out. You go left whilst slowly going down at the same time. Once you get to the edge of the film, you then push slowly right and down until you get to the right edge, then head over to the left edge until the graphic has been completely installed.
If a crease appears whilst you are applying your graphic, don't panic. Simply lift your window graphic up to remove the crease and slowly straight to work left and right again.