NOT ENTIRE LID FOR SALE JUST SEAL FOR LID... COLOR IS ACTUALLY BLACK COLOR IN LISTING IS MADE FROM DRAFT TPU, BUT IS EASIER TO SEE OVER BLACK FOR THE PURPOSES OF PICTURES.

Proof of concept seal for a Ninja Lid that should work with the 72oz pitchers on models BL500-BL781, CT610-CT682SP, and NJ600-NJ602.

The thicker portion of the seal needs to face up so that taper can fit snuggly in the pitcher. You will need to clean off the your existing gasket before installing this seal and this should stay on the lid via pressure, but in the event you want a more permeant solution see below.

If you choose to glue this to the lid I have included groves on the inside lip where you can apply beads of glue, I imagine silicon or urethane will work for this, but I have not tried it yet.

Once glue is applied square it up on the lid and then install the lid overnight into the pitcher so the pressure can help the glue set.

Am looking at feedback in regards to improvements or issues!