Note: the volume kit is the volume mixed , is the total volume, 1:1 mix ratio by volume
16 Oz kit : 8 Oz resin + 8 Oz hardener (Total 16 Oz )
32 Oz kit : 16 Oz resin + 16 Oz hardener (Total 32 Oz )
64 Oz kit : 32 Oz resin + 32 Oz hardener (Total 64 Oz )
1 Gallon kit : 64 Oz resin + 64 Oz hardener (Total 1 Gallon)
2 Gallons kit : 1 Gallon resin + 1 Gallon hardener (Total 2 Gallons)
Tips for operation
This product is 1:1 fast cure resin, each time mixed, pour No more than 150ml total, (that is 75ml A + 75ml B, A must be ≥ B), with a thickness range of ≤1.2" to avoid bursting.
you can go as deep as you like, just make sure to work in stages.
Stay under 1.2" per pour.
After the surface film cures begin your second pour.
the surface set time is roughly 1 hour at room temp.
the full cure time is 8-12 hours in summer and 12-24 hours in winter
the hardness range is 70-80D after full cure
Perfect for tabletops, fiberglass work, small castings (under 1.2" /3CM), electrical potting, jewelry making, concrete - pebble coating, marine applications- boat building, & wood water proofing - repairs.
Features:
Mix Ratio...............1:1 by volume
Work time ..............30-45 minutes
Hardness....................D70-80
Mixed Viscosity..........2500-3500cps.
Chemical Resistance.......excellent
Moisture Resistance........excellent
FDA Compliant / Food grade: Yes, in its inert fully cured state
Heat resistance: up to 80℃ (please don't leave hot pans on it,a coaster needed)
Approximate Coverage: 12 square ft per gallon at 1/8 inch thickness
Approved Applications:
Wood & Metal Coating
Concrete and Pebble Coating
Table,bar tops
Hobbyist,Jewelry and Craft Making
Plaques and Frames
Fiberglass wet lay-up
Waterproofing & Sealing
Important
This chemical needs to be stored in a dry, safe, temperature controlled environment. Always keep the lids tightly sealed when not in use.
Remember, oxygen and moisture oxidize and can rapidly degrade the epoxy and hardener. Moisture is also a potential issue. Always keep the bottles sealed when not in use.
When applying this product, use gloves, goggles, and proper safety equipment. Please refer to the safety data sheet before using any of our epoxy products.
