Step 1-3
- Turn off the water switch.Press the flush pedal to drain water from the toilet
- Lose the stainless steel strip and remove the plastic half clamp to connect the porcelain and plastic base
|
Step 4-5
- Tilt the porcelain bowl forward, grab the vacuum breaker attached to the back of the toilet, and pull it out of the toilet. Put the toilet aside
- Remove original kit.Check flush balls for gaps, scratches or mineral deposits. Cleaning or replacement as necessary
|
Step 6-7
- Place the large plastic disc on the top of the thin seal, through a ring of thin seal raised in the center of the large disc
- Place seal and disk assembly on top of flush ball
|
Step 8-10
- Place the porcelain back on the toilet base, align the notch with the pin on the base, and align the bowl outlet with the flush ball. Then insert the vacuum breaker into the back toilet and push it into the rubber seal ring
- Reinstall plastic half clip under loose steel strip, tighten stainless steel clamp
- Reinstall pedestal cover, turn on water
|