Please contract us firstly if there are any problems when you received the package. We will definitely give you satisfying solution, please don't leave neutral or negative feedback without any communication.
Note:
Item model and Compatibility Table are just a reference, take size as a fitment standard.
In order to avoid to choose Wrong Size item ,please measure car size before purchasing according our size photo.
Make sure the length if you want before you buy,thanks.
The product is made of elastic PU material, which can be bent and adjusted freely.
If it is too long during installation, you need to cut according to the length of your car. If you mind, please do not purchase.
Thank you for your understanding.
Note:
Wrong size for Kia K5 2022
Wrong size for chrysler 300c 2007
Wrong size for BMW 2008 328xi
Not for Audi A5 Quattro 2011 Cabriolet Convertible 2-Door 2.0L 1984CC 121Cu. In. l4 GAS DOHC TurbochargedHyundai i30n 2023
Not for INFINITI G37 2009 Sport Sedan 4-Door 3.7L 3696CC V6 GAS DOHC Naturally Aspirated
Features:
1.Flexible and lightweight PU install in minutes using ultra strong automotive tape
2.No special installation , no drilling or screws required.
3.Gives your ride a more aggressive and customized look.
4.Protect your car from scratches/bump and any undesired damage caused by a collision.
5.This rubber lip is very flexible and can fit to different types of trunk or roof It comes with double side tape on the back for easy installation.
Specifications:
Material: PU Rubber
Size: 1.18-1.38M Adjustable(The product can be trimmed to fit the rear of the car in its own curvature)
Color: Carbon Fiber Look
Fitment: Universal Car
Position: Car Spoiler/Roof/Hatch Gate/Trunk/Bonnet
Package Included:
1 x Car Rear Wing Sticker
Attention:
Measure the length of the rear wing of the car and cut the product according to the length of the rear wing;
1. Simulated installation
Don't tear off the adhesive first, place the product on the car and compare and adjust it to the accurate position.
2 Surface treatment
(1) Cleaning
Use a towel dipped in alcohol or clean the vehicle body with clean water in the area that needs to be installed.
(2) Precautions
Before installation, the vehicle body must be kept dry and free of dust, oil, and wax. When the temperature is below 15 degrees Celsius, it is necessary to heat the adhesive on the vehicle body and product. (Heating with a hair dryer is sufficient)
(3) Installation
Tear off a corner of the protective film on the back of the product, leave the film on the outside to match the installation position, and then slowly remove and press the film.
(4) Protection period
Within 48 hours after the installation of the product (at the adhesive position), it should not come into contact with water, oil, or large dust
Note:
1.Please allow some color and measurement errors due to manual and monitor factors.