Condition :100% Brand New
Material: Vinyl
Size: 59" x 19.68"
Brand new in Bulk Package
Package includes 2 pcs of claw stickers

Installation steps for large car stickers, wet stickers, suitable for large car stickers (two-person operation is recommended) (If you are not sure about the paste, it is recommended to go to the decoration shop to ask the master for help.)
Wet stickers tools: watering can, detergent, clean rag , Scraper, utility knife, hair dryer (with a small amount of detergent in the water)
1. After cleaning the body, spray water with a watering can on the body part to be pasted (mainly used to reduce the viscosity of the sticker and facilitate adjustment of the position).
2. After determining the position to be pasted, lift the transfer film (the transparent adhesive film pasted on the car sticker) and the car sticker from right to left (or from top to bottom) to one side and press it on the car with a rag. On the table, then stick it, flatten it with a rag, and peel off the bottom paper.
3. In case of door handles or anti-collision strips, the materials should be cut and wrapped or cut off according to the situation.
4. Adjust at the right time to determine the general position of the graphics. Use a scraper to repeatedly scrape off water and air bubbles. When using the scraper, scrape diagonally from right to left, and then tear off the transparent transfer film
5. Use a utility knife to separate the door and the seam evenly, and paste it inside.
6. Try to make the moisture in the car sticker dry, and if possible, use a hair dryer to heat and dry it. When the car sticker is to be removed, use a baking gun to heat it in the car wash shop, and then tear it off directly without leaving an offset print and not hurting the paint.