Product Description
Note1:
Pls Use the vehicle fitment we've provided within the body of the listing to confirm vehicle fitment.
Note2:
【No sensor programming Required】:The Tire Pressure Sensor is 100% new and come pre-programmed specifically for your make/model/year of vehicle,need activate them by Right scan tool or "re-learning" Right Activation tool is important,if you wanna Your vehicel Relearn Procedure Description,Pls email us ...
1.Stationary Relearn:Requires the vehicle be placed in the “Learn Mode”.
2.Automatic Relearn:For some vehicles,can be completed by driving.
3.OBD Relearn:Directly writes TPMS sensor IDs to the TPMS module via the OBD connector.
Installation of TPMS is recommended to be performed only by trained professionals.
Specification:
Condition:100% Brand New And High Quality
Battey Life:About 5 Years
Operating Frequency:433Mhz
Manufacturer Part Number:Manufacturer Part Number:40700-4CB0B
Interchange Part Number:40700-4CB1A,40770-4CB1B, 40700-4CB0A
Fitment:
For 2016-2020 Nissan Rogue
For 2017-2020 Nissan Qashqai
For 2019-2020 Altima Leaf
Package Include:
4Pcs Tire Pressure Sensor
Note:
Please enter your vehicle's Year, Make, Model, Trim and Engine in the Compatibility Table. The Compatibility Is Just For Reference.Please check the picture and the part number carefully to make sure that you bought the right part for your car.The only way to be 100% sure that the part will fit your vehicle is to check your part,You can also email us before purchasing, we will check for you and reply soon within 24 hours.
■ Installation Process for reference only:
1.Loose the tire:Remove the valve cap and core and deflate the tire.
2.Dismount the tire:Clamp the tire onto the tire changer, and adjust the valve at 1 o’clock relative to the tire separation head.Insert the tire tool and lift the tire bead onto the mounting head to discount the head.
3.Dismount the sensor:With a screwdriver remove the fastening screw and sensor from the Valve stem, then loosen the nut and remove the valve.
4.Mount sensor and valve:Slide the valve stem through the valve hole of the rim. Tighten the screw-nut with 4.0 Nm with the help of the positioning pin.Assemble the sensor body against the rim and tighten the screw.
5.Mount the tire:Place the tire on the rim,making sure that the valve faces the separation head at an angle of 180 degrees.Mount the tire over the rim.